Description
The purpose of this sources sought notice is to conduct market research and identify potential sources of commercial products/services that satisfy the Government's anticipated needs. BACKGROUND The National Institute of Standards and Technology (NIST), the Fundamental Thermodynamics group at the Sensor Science Division is conducting Standard Photonic Thermometer (SPoT) project. The main focus of the project is to develop the next-generation chip-scale photonic temperature metrology that can replace Standard Platinum Resistance Thermometers (SPRTs), reduce the temperature calibration chain and sensor ownership cost. The SPoT project, pursued by The Fundamental Thermodynamics group, is a multi-year/multi-million effort funded by both NIST-on-a-Chip (NOAC) and Air Force. The timely achieving project's milestones is NIST-mission-critical task and is one of the priorities of the Physical Measurement Laboratory (PML). One of the essential milestones of Standard Photonic Thermometer is to develop both high-resolution photonic readout capabilities, as well as cost-efficient and deployable photonic readout systems. To achieve these essential for the project milestones, the Fundamental Thermodynamics group has a critical need for one (1) high-resolution and one (1) low-resolution wavelength meters. The high-resolution wavemeter should come with 4-channel optical switch and 4-channel PID controller. Both instruments must be from the same manufacture to ensure software compatibility. The instruments are essential for achieving the precision and stability necessary in next-generation temperature metrology NIST is seeking information from sources that may be capable of providing a solution that will achieve the objectives described above, in addition to the following essential requirements: The Contractor shall provide the following one (1) wavelength meter in the near infrared (NIR) frequency range that meets the following minimum specifications: High-resolution wavemeter The wavelength meter that operates over a range of at least 630 nm to 1700 nm. The system shall pre-aligned 9/125 μm single-mode fiber with FC/APC optical fiber input connector. Input laser type: CW and pulsed Minimal input optical power: 50 nJ, or less Maximum input optical power: 10 mW (CW) / 0.5 mJ (pulse), or more Input laser light maximum bandwidth (FWHM) shall be 1 GHz or larger. Wavelength measurement accuracy ±0.2 part per million (ppm) fractional wavelength error over the entire operating range; ±60 MHz at 1000 nm, or better. The wavelength meter must reach this accuracy with a warm up period of less than 15 min. The wavelength resolution 0.001 ppm or better, 300 kHz @ 300 THz The wavemeter stability/repeatability over 1 minute shall be better than 3 MHz. 10. The measurement rate of the wavelength meter shall be at least 1 kHz or faster. 11. The wavemeter shall have a built-in PID controller and an automatic internal calibration locked to a known sta…
Classification
Place of Performance
Contracting Office
Contacts