TPT Manual Wire Bonderview on SAM.gov

NIST-SS26-09 6640 / 333242 Primary POC: Liz Timberlake (Elizabeth.timberlake@nist.gov) Secondary POC: Forest Crumpler (forest.crumpler@nist.gov) Title: TPT Manual Wire Bonder BACKGROUND ***THIS IS A NAME BRAND NAME ONLY SOURCES SOUGHT NOTICE *** The National Institute of Standards and Technology (NIST) is seeking information from sources that may be capable of providing a TPT manual wire bonder. The North American Industry Classification System (NAICS) code for this acquisition is 333242. NIST has a need for a TPT manual wire bonder that meets or exceeds the following draft minimum specifications: Technical specifications. The wire bonder shall be capable of wedge, ball and ribbon wire bonding. The wire bonder shall allow a trained user to reconfigure the wire bonder for each of these bonding modes within 5 minutes. The wire bonder shall be capable of manual operation, where the X and Y positioning of the sample and Z position of the bonding tool are all manually controlled by the user. The system shall support gold wire diameters from 17 um to 75 um (0.7 mil to 3 mil). The system shall support aluminum wire diameters from 17 um to 75 um (0.7 mil to 3 mil). The system shall support ribbon wire width from 20 um to 250 um. The system shall have an ultrasonic transducer with PLL control operating between 60 and 70 kHz. The system shall provide an ultrasonic power output range from 0 to 10 W. The system shall provide a bond time range from 0 ms to 20,000 ms. The system shall provide a bond force range from 5 cN to 200 cN. The system shall use a 90 degree wire feed angle. The system shall have a motorized clamp for wire. The system shall have a throat depth greater than or equal to 165 mm. The system shall have a fine table motion greater than or equal to 15mm. The system shall have a temperature controller with upper limit greater than or equal to 250 C. The system shall have a temperature controller with the temperature accuracy of +/- 1C or better. The system shall be tabletop size that is smaller than 600 x 600 x 300 mm Operation interface specifications The system shall have an integrated operator interface. The system shall have a display for the interface. The system shall support storage of at least 20 bonding programs or recipes. The system shall provide direct access and simple adjustment of bond parameters through the user interface. HOW TO RESPOND TO THIS NOTICE In responding to this notice, please DO NOT PROVIDE PROPRIETARY INFORMATION. Please include only the following information, readable in either Microsoft Word 365, Microsoft Excel 365, or .pdf format, in the response. Submit the response by email to the Primary Point of Contact and, if specified, to the Secondary Point of Contact listed at the bottom of this notice as soon as possible, and preferably before the closing date and time of this notice. Provide the complete name of your company, address, name of contact for follow-up ques…