Custom Metal Fabrication Services for Specialty Tactical Shelters and Ancillary Equipmentview on SAM.gov

Amendment 3 Q: Sheet 1 carries a marked note that the U-Channel is not shown correctly in Detail A or the Top and Bottom views. Can the Government confirm/issue a corrected Detail A and Top/Bottom view for the U-Channel (Find No. 3, Dwg. 17-3-4854) before award, or advise which view governs in the interim? A: Drawing 17-3-4854 was revised and an updated drawing package was uploaded to the announcement. Side view in 17-3-4850, Detail B, shows the correct positioning of U Channel, 17-3-4854. Q: The U-Channel detail sheet specifies cross-section (2.00″ × 1.00″, .125″ wall) but does not dimension overall cut length. Please confirm the required finished length for the four U-Channel pieces called out on the weldment parts list (17-3-4851). A: Drawing 17-3-4854 was revised and an updated drawing package was uploaded to the announcement. Q: Drawing calls out Aluminum 6061-T6 and 6063-T5 per ASTM B221 throughout. Please confirm whether DFARS 252.225-7009 (specialty metals domestic melt/production) applies to this item, and whether mill test reports/certificates of conformance must accompany each delivery lot. A: Unless otherwise stated, DFARS 252.225-7009 would not apply for purchases under the Simplified Acquisition Threshold (SAT). Mill test reports/certificates of conformance are only required if stated on a purchase order. Q: Removable panel spacer is specified as Nylon 6 (polyamide), off-white. Please confirm whether a specific commercial grade/durometer or flame-retardancy rating is required, or whether generic Nylon 6 stock is acceptable. A: For this product, generic Nylon 6 stock is acceptable. Q: Please confirm acceptable substitute/equivalent aluminum tempers or alloys (e.g., alternate 6000-series) in the event of raw-material supply disruption, and the process for requesting a material deviation. A: Material deviations should be requested in writing (email), with supporting documents (material data, mark-up of drawings) and will require acceptance by the product engineers (final customer). Q: Drawing calls for welding IAW ANSI D1.2. Please confirm whether a specific filler alloy (e.g., 4043 vs. 5356) is required or left to the fabricator's WPS, and whether WPS/PQR must be submitted for Government approval prior to production. A: For this product, the government does not require approval of WPS and PQR. Other products may have additional welding requirements stated on the drawings or purchase order. Q: Please confirm the required weld inspection method and acceptance criteria — visual only per AWS/ANSI D1.2, or is additional NDE (e.g., dye penetrant) required on any joint? A: For this product, the government does not require additional NDE. Other products may have additional inspection requirements stated on the drawings or purchase order. Q: Rivets (MS24243/5A304, MS24243/5A406) and rivet-mount nut (MS21075-4N) are called out by standard number only. Please confirm no additional finish/pla…