Advanced GNSS Simulatorview on SAM.gov

*****This announcement is not a formal Request for Quotes (RFQ). This SSN/RFI is for informational and planning purposes only and does not guarantee that an award will be made. Any quotes submitted in response to this SSN/RFI are not quotes on which an order will be issued. The Government assumes NO financial responsibility for any costs incurred. A solicitation package is not available at this time. However, should such a requirement materialize, no basis for claims against NRL shall arise as a result of a response to this SSN/RFI or NRL's use of such information either as part of our evaluation process or in developing specifications or work statements for any subsequent requirement. PURPOSE AND ACQUISITION BACKGROUND The purpose of this notice is to identify potential industry sources capable of delivering a high-precision, multi-channel Advanced Global Navigation Satellite System (GNSS) Simulator suite. This requirement will support critical Position, Navigation, and Timing (PNT) research, development, and testing spanning dual-frequency GPS baselines, encrypted military signals (SAASM and AES M-Code), full-spectrum multi-constellations, Low Earth Orbit (LEO) Alternative Navigation (ALTNAV), lunar S-band PNT, contested/threat environments, and multi-element Controlled Reception Pattern Antenna (CRPA) wavefront testing. SALIENT CHARACTERISTICS & TECHNICAL SPECIFICATIONS The required capability consists of a minimum of two (2) discrete simulation units meeting the essential physical, electrical, and functional characteristics detailed below. Essential Physical and Electrical Characteristics (Applicable to Both Units) Essential Physical Characteristics Mounts in standard width 19-inch rack mount and includes mounting brackets. Mountable rack units less than or equal to 27 inches of depth. Stable operation over temperature range of 10degC to 40degC and 40% to 90% relative humidity, non-condensing. RF output ports are located on front and rear of chassis and are Type N female connector. RF connector ports are all 50-ohm impedance. Minimum of one combined RF output Type N female connector for high-power generation (+50dB above nominal). BNC female connector for 1 Pulse Per Second (PPS) input for syncing to external pulse. BNC female connector for 1 Pulse Per Second (PPS) output from simulator to provides a precise hardware timing reference signal of the simulated UTC second. BNC female connector for trigger input port to start or synchronize a scenario run. BNC female connector for an external 10 MHz reference input. BNC female connector for 10Mhz internal reference output. At least four (4) Universal Serial Bus (USB Type-A, 3.0 or higher) ports on rear panel and 2 USB (Type-A, 3.0 or higher) ports on front panel for I/O connections. At least one video interface option must be DisplayPort (DP 1.4a or higher) or High-Definition Multimedia Interface (HDMI 2.1 or higher). Trusted Platform Module (TPM) 2.0 or higher included on computer to address Secu…