Sources Sought: Construct Combat Rescue Helicopter Simulator Facility at Moffett ANGBview on SAM.gov

This Sources Sought Solicitation is being issued in accordance with RFO FAR Part 10, Market Research . The purpose of this notice is to gain knowledge of potential sources for this project including interested Small Business Concerns. Its sole purpose is to provide information for planning and market research purposes only and shall not be construed as either a solicitation or obligation on the part of the Government. The Government welcomes responses from all interested parties; however, no decision or award of contract will be made based on responses from industry. The Government will not pay for the preparation of, nor the subsequent use of, information submitted in response to this Solicitation. Respondents will not be notified of the outcome of the Government's review of the information received. Additionally, the Government does not intend to hold discussions concerning this Solicitation with any interested parties but reserves the right to contact vendors if additional information is required for clarifications as it pertains to the Solicitation. Project Information The Contractor shall provide non-personal services, to include all plant, labor, transportation, materials, tools, equipment, appliances, and supervision necessary for the construction of a Combat Rescue Helicopter (CRH) Operational Flight Trainer (OFT) simulator facility at Moffett Air National Guard Base (ANGB), Mountain View, California. The magnitude of construction for this effort is $10,000,000 to $25,000,000. This project will provide an approximately 8,202 gross square foot building consisting of a multi-story, high bay area to house the CRH-OFT simulator, with a single-story area containing CRH mission planning, briefing and debriefing rooms, administrative areas for training and support staff, OFT maintenance and parts storage rooms, secure and non-secure tele-communication rooms, latrine facilities and mechanical, electrical and utility support rooms utilizing conventional design and construction. The building will be of permanent construction with electrical, mechanical, HVAC, plumbing, wet sprinkler fire suppression, fire detection, access control, direct digital control, and utility management. The exterior walls will be constructed with cavity wall construction including interior non-load bearing metal studs (or CMU wall backup at Simulator Bay) with gypsum board and exterior CMU veneer and metal panel. Air space and insulation to be located inside the cavity wall to meet Energy Code requirements. The primary roofing materials will be standing seam metal roofing to match other installation facilities and the perimeter sloped roof design will include a prefinished standing seam metal roof panel system over rigid insulation. The exterior walls will be constructed with cavity wall construction including interior non-load bearing metal studs (or CMU wall backup at Simulator Bay) with gypsum board and exterior CMU veneer and metal panel. Main entrance doors…